Turn the unit off before replacing the recharge- able batteries. Never mix dry cell and rechargeable batteries. Slide the lid back into place horizontally. (Remove LR03 (UM-4) batteries in the same way.) Push up on the battery in the direction indicated by the arrow. The unit and wired remote control have HOLD func- tions, each of which works independently. The indicator lamp flashes when charging and will be constant on when charging is complete. The unit is powered on accidentally when not in use, causing the batteries to run down.Ī button is accidentally pressed during play, interrupt- ing the operation. The 2 indicator lamps display the status of the battery. The HOLD function prevents the following:
(The disc lid can still be opened and closed.) This function causes the unit to ignore short, accidental button presses. When the unit is in HOLD mode, pressing any button causes the indication “īefore operating the buttons Be sure to move to release the unit from the HOLD mode. Re-connect the power source and continue op- eration. If the unit malfunctions or freezes during use, disconnect the power sources (the AC adaptor or batteries). Refer to the specifications (page 6) for information on operating times when using rechargeable batteries or dry cell batteries. The car adaptor can be used to recharge the unit’s bat- teries while in the car. The battery indicator may not flash if rechargeable batter- ies other than those designated by Panasonic are used.īe sure to obtain the car adaptor (SH-CDC9), available as an optional accessory. The length of time the unit will continue to operate be- tween when the battery indicator starts flashing and when the power is cut off differs depending on the type of batteries used. Dry cell batteries: Replace batteries with new ones. Rechargeable batteries: Recharge batteries. Power is cut off completely a short while later. This indicator flashes when the batteries are almost out of power. After recharging the batteries and dis- connecting the AC adaptor from the AC power outlet, ensure you disconnect the AC adaptor from the unit’s [DC IN 4.5 V Leaving the AC adaptor connected can cause the bat- teries to go flat. The AC adaptor and rechargeable batteries may be- come warm while recharging is in progress. Recharging may only be performed when the unit is powered off. The batteries have reached the end of their operational life if they last for a noticeably shorter time after recharging, or if they cannot be recharged at all. Rechargeable batteries have a service life of approxi- mately 300 charge-discharge cycles. When charging is complete, unplug the AC adaptor from the household mains socket and DC IN jack. The indicator goes out when charging is complete.
(Refer to “Using the AC adaptor”.) Recharging starts and the “įlashes on the unit’s display. (Refer to “Using the dry cell batteries”.) Obtain the optional rechargeable batteries:įor United Kingdom: P-3GAVE/2B For Others: P-3GAVT/2BĪAA (UM-4) nickel-metal hydride rechargeableįor United Kingdom: HHR-4AHE/2B For Others: HHR-4AHT/2B This unit cannot recharge batteries other than those especially designed for it. Use either AA (UM-3) batteries or, by inserting the supplied adaptor, AAA (UM-4) batteries. Using the rechargeable batteries (not included) Turn the unit off before replacing the dry cell batteries. Reverse the above procedure to remove the adaptor.
Insert two LR6 (UM-3) alkaline batteries or two LR03 (UM-4) alkaline batteries using the supplied adaptor. Using the dry cell batteries (not included)
Turn the unit off before connecting or disconnecting the AC adaptor. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. The unit is in the standby condition when the AC adaptor is connected. The charger has four LEDs, signaling the charging process.The configuration of the AC adaptor differs according to the area. The progress of charging and its completion is controlled by the Smart Charge function, which automatically checks the voltage and temperature of the batteries. 1, 2, 3 or 4 batteries can be charged at the same time. The charger has 4 separate charging channels. The BQ-CC55 is a fast and perfectly made microprocessor-controlled charger. charging indicator in the form of 4 multi-colored LEDs.microprocessor controlling battery charging.1, 2, 3 or 4 R6/AA or R03/AAA batteries can be charged at the same time.charger designed to charge NiMH batteries type R6/AA and R03/AAA.
0 kommentar(er)
